Maintenance precautions for the daily use of the incubator - Huaqiang Electronic Network

In addition to following the instructions for use in daily operation, there are several important considerations when using an incubator to ensure safe and efficient performance:

1. Always place the incubator on a flat, stable surface. If the ground is uneven, make sure to level it properly. The equipment should be used in an environment where the temperature is below 30°C. If the ambient temperature exceeds this, consider installing ventilation at the back of the unit or placing it near an air conditioner. This helps prevent overheating, which can cause the compressor to malfunction.

2. Never place flammable or volatile substances inside the incubator. These materials can pose serious safety risks and may damage the internal components of the device.

3. When moving the incubator, always tilt it no more than 45 degrees. Never transport it upside down, as this can damage the internal structure and affect its performance.

4. Keep the incubator away from sources of electromagnetic interference and ensure it is properly grounded. This helps maintain stable operation and prevents electrical issues.

5. Avoid overloading the incubator with too many items. Make sure there is enough space between objects to allow proper air circulation. This ensures even temperature distribution and improves efficiency.

6. If lighting is not required, turn it off. This not only extends the life of the lamp but also helps prevent excessive heat buildup in the upper section of the incubator.

7. If you notice any unusual odors or smoke during operation, immediately turn off the power and contact a qualified technician for inspection and maintenance. Do not attempt to fix it yourself.

8. Regularly clean the inner walls and lining of the incubator using only clean water. Avoid using acidic or alkaline solutions, as they can corrode the surfaces and reduce the lifespan of the equipment.

9. If the incubator will not be used for an extended period, unplug it and store it in a dry location. It's recommended to perform a test run every three months to ensure all systems are functioning correctly.

10. In case of moisture buildup inside the incubator, drain the water from the bottom tray. Set the temperature to 42°C and let it run for five hours. Open the door every two hours to release humidity. Afterward, unplug the device and allow it to dry completely before storing.