Maintenance precautions for the daily use of the incubator - Huaqiang Electronic Network

When using an incubator, it's important to follow the user manual and pay attention to some key maintenance tips to ensure safe and efficient operation.

1. Place the incubator on a flat and stable surface. If the floor is uneven, level it properly. Keep the device in an environment where the temperature is below 30°C. If used in higher temperatures, consider installing ventilation at the back or placing it near an air conditioner to prevent overheating of the compressor.

2. Avoid putting any flammable or volatile materials inside the incubator to prevent damage or safety hazards.

3. When moving the incubator, always tilt it less than 45 degrees. Do not transport it upside down.

4. Keep the incubator away from electromagnetic interference and ensure it is properly grounded for safe operation.

5. Avoid overloading the incubator. Make sure there are enough air gaps between items to maintain proper airflow and consistent temperature distribution.

6. If lighting is not needed, turn it off to extend the life of the bulb and avoid excessive heat buildup in the upper part of the unit.

7. If you notice unusual odors or smoke during use, immediately turn off the power and contact a qualified technician for inspection and maintenance.

8. Regularly clean the inner walls and lining with water only. Avoid using acidic or alkaline solutions that could corrode the surfaces.

9. If the incubator will be unused for an extended period, unplug it and store it in a dry place. It’s also recommended to run it once every three months to keep it in good working condition.

10. In case of internal moisture, drain the water from the tank into the tray. Set the temperature to 42°C and run the incubator for five hours, opening the door every two hours to release humidity before unplugging the device.