- Model NO.: XR101
- Transport Package: Carton, Wooden Case
- Origin: China
- Trademark: Ramsey
- Specification: 0.2Kg
introduction:
Squared XR101 magnetic resistance type speed sensor is high cost performance, a wide range of general rotating speed sensor is used to guide magnetic speed measurement of the object, using non-contact measurement methods.Inside the sensor is composed of magnetic steel, soft magnetic coil and armature.The basic measuring principle is (lines) issued by the magnet, magnetic field through the armature and coil, when there is a magnetic object magnetic flux change in the near or far away from the coil, induction coil of electromotive force, and coil inside gear shaft speed), induction and speed is proportional to the frequency signal;If is involute gear, the induced voltage is a sine wave.Is proportional to the size and speed signal amplitude of the probe end and tip clearance is inversely proportional to the size.
L performance characteristics
1. The non-contact measurement, do not contact with moving parts are being tested, no wear and tear
2. Using magnetoelectric induction principle, without external power supply, the output signal is big, do not need to enlarge, anti-interference performance is good
3. The integrated design, simple structure and reliable, has the very high resistance to vibration and impact resistant properties
4. To adapt to the working environment temperature range is wide, suitable for harsh industrial environments, such as smoke, oil and gas and moisture environment
Ø electrical indicators:
250 to 550 Ω squared straight flow resistance: (25 ºC)
Squared work temperature: - 30 to + 100 ºC
Ø physical indicators:
Squared weight: about 120 g
Squared vibration-proof move: 20 g
Squared thread specification: M16 x 1
Squared installation clearance: 0.5-1.0 mm, it is recommended that the 0.8 mm
Squared material quality: 304 stainless steel
Squared gear material: gear material permeability strong metal materials should be adopted.
Squared tooth profile: involute tooth profile is the most appropriate tooth profile.With big modulus gear or with other tooth will produce a great waveform distortion, which will interfere with accurate measurement.If the main shaft axial movement, the attention should be paid to the center of the pole should be in the center of the gear.
Module of gear: 2 to 4 tooth width b: more than 5 mm.
Squared work temperature: - 10 to + 100 ºC
Ø order guidelines:
Squared XR101 - AXX - BXX - CXX - DXX
The sensor length AXX: 01-60 mm
02-80 - mm
03-120 - mm
04 - special specifications (maximum length is 300 mm)
Thread specification BXX: 01 - M16 x 1
Special specifications.
Cable length CXX: increasing when placing order, to 1 m, for example: 010 = 1.0 m,
The default 2 m
Joint options DXX: 0 1 - lead directly
0 2 - aviation plug
Â
1.00Mm Wafer Connector,1.0Mm Single Row Smt Wafer Connector,1.0Mm Smt Wafer Connector,1.0Mm Dual Row Smt Wafer Connector
Shenzhen CGE Electronics Co.,Ltd , https://www.cgeconnector.com