The northeast has cooled over the past few days. I feel that I must prepare for the arrival of the winter. I also remember the old saying "Winter Is Coming" from the Stark family.
Waiting for the double 11 is not urgent, ready to configure a new PC, since it is to feel the chill of the winter, to install a white theme of the computer bar, the chassis first arrived: first horse ark, but the white is still rarely seen, here and Share it with everyone:
This box is quite large, long X wide X high: 520x248x530MM, but because it is white, looks more delicate, will not feel too fat.
Side through the use of two sides through the surface, but also a whole block, a bit like to disguise the side of the glass through, but the actual material is acrylic, the color is a bit dark. Such a large area of ​​acrylic static electricity is still very powerful, vacuuming a bit powerful.
The shape is convenient to do a lot of diamond-shaped section, add some science fiction elements.
The top of the chassis has SD/TF card reader, LED control buttons, fan control buttons (low speed, stall, high speed three grades)
The chassis front I/O includes dual USB 3.0, dual USB 2.0, Mic jack, Ear jack, hard disk light, reset button, and power button.
The front and back of the chassis are still very wide. There are SAMA's LOGO on the left side of the front, and there is also a belief light after the boot. The PCIE slot is 8, and some manufacturers will promote the whole tower, but it looks like the first horse. Still quite honest, JD's introduction is still in the tower.
The back is also an entire acrylic side, the same as the front.
The bottom of the chassis is provided with non-slip mats that have some height, but there is also a large indentation inside to facilitate the air inlet of the power supply. The dustproof net cover of the power supply can be removed by pulling.
The chassis has snap-type dust-proof heat-dissipating nets at the top and front, and the removal is very easy.
The fan part is the first customized solar wind 12cm LED fan, with 5 standard.
There are also 2 fans in the front, but you can also install a 14cm fan, if the standard 14cm fan is perfect.
Look at the internal structure: still maintain the mainstream of the power under the design, the traditional hard disk shelf in front of the chassis into a wall-mounted three 2.5-inch hard disk rack, so that the front of the space is relatively empty, if you choose to install water cooling this part of the space will be able to make full use of Now.
The most important thing is that the interior is painted white, and the inside and outside are white!
The wall-mounted disk tray can be removed, and it is screw-free. Even the optical disk drive can be removed. The optical disk drive is designed with care. The corners are rubber and are not afraid of being scratched.
Behind the chassis, there are three 3.5-inch hard disk shelves, but also compatible with 2.5-inch hard disk; behind the line is still quite a lot.
Remove the hard disk holder, pay attention to have a small opening before and after, because it is free of screws, you need to put the hard drive into the buckle, there is a small opening is much easier; and 2.5-inch hard disk shelf does not have this design, with A bit of brute force to install a 2.5-inch hard drive.
Chassis comes with controller, large D power supply, fans, light bar, etc. are controlled by this, the color is red, blue, green, purple, yellow, blue, white seven kinds of monochrome, can also be set to circulatory respiratory effects. After the lights are set, the original settings will remain after the power is turned off and on again.
The fan's interface is six pin, and the traditional fan interface is not universal; in addition to the top of the LED control button and fan control button for a six-pin wiring need to be connected to the upper right corner of the control bit, otherwise it will control the failure.
The top and front panels of the chassis can be removed with violence. There are light bars on the two sides of the front panel, which can also control discoloration.
The skeleton structure of the chassis can be seen that there is only a 12cm fan hole at the top, and a 14cm fan cannot be installed.
The space of the back line is more than 3cm, the difficulty of the line management should not be great; the hole of the line is also more, and it also comes with a Velcro.
Chassis advantages:
1) White has not yet increased its price, and it is still a conscience.
2) The internal space is large, you can install EATX motherboard; water-cooled or dual-card is a good choice.
3) The standard five-color seven-color fan is also very affordable, you can also buy first horse's own light bar and LED fan, so that light pollution to more violent!
Disadvantages:
1) If you do not choose water cooling, if you have an optional hard disk mount, you can use the space more fully.
2) The front of the bottom of the chassis, that is, no fan holes and no hard disk holes, is also a pity.
Basically other hardware, equipment installed, look forward to my installed article!
