The patch panel is a must-have tool for modern families. The use of electrical equipment must be powered. The patch panel can not only connect electrical equipment, but also facilitate the use of household electricity. However, we may splash water on the power strip due to mistakes and other reasons, causing the disconnected version to enter the water. What should we do after the plug-in board enters the water? Can the patch panel continue to be used after it enters the water? The following small series will answer your questions.
First, how to do the plug-in board into the water? Can I continue to use it after entering the water?
In places like restaurants or bathrooms in our homes, it is very possible to accidentally spill water into the patch panel, because these places are where the water flow is large. So the first step we have to do is to turn off the power outlets. Disassemble the power strips and blow them dry with a hot air blower.
If there is a serious situation where the water in the patch panel is very serious, it can be used after the correct cleaning. First, you need to open the panel for cleaning. There must be no water residue and then reinstall. The plug is fully inserted during use, on the one hand for the stable operation of the appliance, and on the other hand to prevent the occurrence of electric shock accidents.
Finally, we should pay attention to the use of the plug, such as this plug is best used in the bedroom or living room, dry place away from the liquid. If you can't avoid taking certain isolation measures for the plug, if the plug is in contact with water, it is not a short circuit or an open circuit. Pay attention to the dirt inside the socket and do not touch it when it is wet.
Buy and sell treasures to provide you with a variety of plug-in boards, quality assurance, such as Gowone purchase multi-function patch panels, flame retardant lightning protection and durable, and when the electrical load exceeds the rated power of the plug, the overload red switch will The power is automatically turned off to protect the safety of the circuit.
Second, the use of the power strip after the water into the water
If the plug-in board comes into the water, you have carefully processed it by your method, and then you need to re-install it and then continue to use it. This method is not advisable. Should be checked by a professional, if the socket temperature is too high or there is a fire, the plug and the socket are not in good contact. When the plug is inserted too loosely or too tightly, it should be stopped and repaired or replaced to ensure safety.
Since we have had a mistake after the plug-in board has entered the water, we have to do some protective measures to avoid the water in the socket. There are often water and fumes in the kitchen and bathroom. It is best to install a splash-proof box or plastic baffle on the socket panel to prevent short circuit caused by oil and water vapor intrusion.
Zysen offer Straight Waveguide, from WR6 to WR975, length is customized according to requirement, Quick lead time 2 to 3 weeks.
H Bend Waveguide,Straight Waveguide,Waveguide Pressure Window,Microwave Straight Waveguide
Chengdu Zysen Technology Co., Ltd. , https://www.zysenmw.com