OFweek robot network: First, the R series gear reducer installation and use precautions
1. When installing R series reducer, pay attention to the alignment of the center axis of the transmission, and the error should not be greater than the compensation amount of the coupling used. Good alignment can extend the service life and achieve the desired transmission efficiency.
2. When installing the transmission member on the output shaft, it is not allowed to strike with a hammer. Usually, the internal jigs of the assembly jig and the shaft end are used to press the transmission member with bolts, otherwise the internal parts of the reducer may be damaged. It is better not to use a steel fixed coupling. Due to the improper installation of this type of coupling, unnecessary load will be caused, resulting in early damage of the bearing and even breakage of the output shaft in severe cases.
3. The reducer should be firmly installed on a stable level foundation or base. The oil in the oil drain should be removed and the cooling air circulation should be smooth. The foundation is unreliable, causing vibration and noise during operation and impairing bearings and gears. When the transmission coupling has protrusions or gears and sprocket transmissions, it should be considered to install protective devices. When the output shaft is subjected to large radial loads, the reinforcement type should be selected.
4. According to the specified installation device, the staff can conveniently approach the oil mark, vent plug and drain plug. After the installation is in place, the accuracy of the installation position should be thoroughly checked in order, and the reliability of each fastener should be flexibly rotated after installation. The reducer is splashed and lubricated in the oil pool. Before running, the user needs to remove the screw plug of the vent hole and replace it with a vent plug. According to different installation positions, and open the oil level plug screw to check the height of the oil level line, refuel from the oil level plug until the lubricating oil overflows from the oil level plug screw hole, and then screw the oil level plug to make sure it is correct before emptying The test run shall be no less than 2 hours. The operation should be smooth, without impact, vibration, noise and oil leakage. If abnormalities are found, they should be eliminated in time.
Nebulizing Diffuser is a specific type of Ultrasonic Aromatherapy Diffuser that uses the process of nebulization to achieve evaporation. This process forces the breakdown of essential oils into very tiny particles and requires a high velocity, pressurized air stream as well as specially designed jet nozzle. The rate of evaporation is highly accelerated and occurs almost instantly. The particles of essential oil reach you in their natural state and provide you with all of their original therapeutic benefits. With this method the essential oil is not diluted by water so it is much more powerful. Also, no heat is required so the chemical structure of the essential oil is not altered Simply add your favourite essential oil, sit back and relax!
USB chargeable Nebulizing Essential Oil Diffuser with minimal design. Compact-size fits perfectly for your home, office, cars and your suitcase for travel. Unique atomizing technology to provide you the purest and undiluted aroma.
Points for Nebulizer Oil Diffuser: No water or heat ; Atomizer technology ; Pure essential oils.
Nebulizing Diffuser
Nebulizing Diffuser,Nebulizing Essential Oil Diffuser,Nebulizer Oil Diffuser,Ultrasonic Aromatherapy Diffuser
Shenzhen Dituo Electronic Co.,Ltd. , https://www.sz-dituo.com